AIChannelCollection.CreateTedsAccelerometerChannel Method (String, String, Double, Double, AIExcitationSource, Double, AIAccelerationUnits)

public AIChannel CreateTedsAccelerometerChannel(
	string physicalChannelName,
	string nameToAssignChannel,
	double minimumValue,
	double maximumValue,
	AIExcitationSource currentExcitationSource,
	double currentExcitationValue,
	AIAccelerationUnits units
)

Public Function CreateTedsAccelerometerChannel ( 
	physicalChannelName As String,
	nameToAssignChannel As String,
	minimumValue As Double,
	maximumValue As Double,
	currentExcitationSource As AIExcitationSource,
	currentExcitationValue As Double,
	units As AIAccelerationUnits
) As AIChannel

Parameters

physicalChannelName

Type: SystemString
The names of one or more physical channels to use to create one or more local virtual channels.

nameToAssignChannel

Type: SystemString
One or more names to assign to the created local virtual channels. To use the physical channel name as the local virtual channel name, set this value to Empty.

minimumValue

Type: SystemDouble
The minimum value expected from the measurement, in units.

maximumValue

Type: SystemDouble
The maximum value expected from the measurement, in units.

currentExcitationSource

Type: NationalInstruments.DAQmxAIExcitationSource
The source of excitation.

currentExcitationValue

Type: SystemDouble
The amount of excitation in amps that the sensor requires. Refer to the sensor documentation to determine this value.

units

Type: NationalInstruments.DAQmxAIAccelerationUnits
The units to use to return the acceleration measurement from the channel.

Return Value

You must configure the physical channel(s) with TEDS information to use this method.

The NI-DAQmx driver does not determine if the requested settings are possible until the task is verified. This method does not throw an exception for parameter values that are not compatible with your hardware or other settings in your task. To determine if all of the settings for a Task are valid, you must verify the task by starting the task, either with Start or by reading from or writing to the task, or by calling Control(TaskAction) with Verify.

Reference