DCPowerOutputSourceOutputCutoff Properties
- Updated2024-01-04
- 3 minute(s) read
DCPowerOutputSourceOutputCutoff Properties
The DCPowerOutputSourceOutputCutoff type exposes the following members.
Properties
| Name | Description | |
|---|---|---|
 | CurrentChangeLimitHigh |
Specifies a limit for positive current slew rate, in amps per microsecond, for output cutoff. If the current increases at a rate that exceeds this limit, the output is disconnected.
|
| CurrentChangeLimitLow |
Specifies a limit for negative current slew rate, in amps per microsecond, for output cutoff. If the current decreases at a rate that exceeds this limit, the output is disconnected.
|
| CurrentMeasureLimitHigh |
Specifies a high limit current value, in amps, for output cutoff. If the measured current exceeds this limit, the output is disconnected.
|
| CurrentMeasureLimitLow |
Specifies a low limit current value, in amps, for output cutoff. If the measured current falls below this limit, the output is disconnected.
|
| CurrentOverrangeEnabled |
Enables or disables current overrange functionality for output cutoff. If enabled, the output is disconnected when the measured current saturates the current range.
|
| Delay |
Delays disconnecting the output by the time you specify, in seconds, when a limit is exceeded.
|
| Enabled |
Enables or disables output cutoff functionality. If enabled, you can define output cutoffs that, if exceeded, cause the output of the specified channel(s) to be disconnected.
|
| VoltageChangeLimitHigh |
Specifies a limit for positive voltage slew rate, in volts per microsecond, for output cutoff. If the voltage increases at a rate that exceeds this limit, the output is disconnected.
|
| VoltageChangeLimitLow |
Specifies a limit for negative voltage slew rate, in volts per microsecond, for output cutoff. If the voltage decreases at a rate that exceeds this limit, the output is disconnected.
|
| VoltageMeasureLimitHigh |
Specifies a high limit voltage value, in volts, for output cutoff. If the measured voltage exceeds this limit, the output is disconnected.
|
| VoltageMeasureLimitLow |
Specifies a low limit voltage value, in volts, for output cutoff. If the measured voltage falls below this limit, the output is disconnected.
|
| VoltageOutputLimitHigh |
Specifies a high limit voltage value, in volts, for output cutoff. If the voltage output exceeds this limit, the output is disconnected.
|
| VoltageOutputLimitLow |
Specifies a low limit voltage value, in volts, for output cutoff. If the voltage output falls below this limit, the output is disconnected.
|