DCPowerOutputLCRAdvanced Properties
- Updated2024-01-04
- 3 minute(s) read
DCPowerOutputLCRAdvanced Properties
The DCPowerOutputLCRAdvanced type exposes the following members.
Properties
| Name | Description | |
|---|---|---|
 | ACDitherEnabled |
Specifies whether dithering is enabled during LCR measurements. Dithering adds out-of-band noise to improve measurements of small voltage and current signals.
|
| CurrentRange |
Specifies the current range, in amps RMS, that defines the values to which you can set the CurrentAmplitude for the specified channel(s). For valid ranges, refer to the specifications for your instrument.
|
| DCBiasCurrentRange |
Specifies the DC bias current range, in amps, that defines the values to which you can set the DCBiasCurrentLevel for the specified channel(s). For valid ranges, refer to the specifications for your instrument.
|
| DCBiasTransientResponse |
For instruments in LCR mode, determines whether NI-DCPower automatically calculates and applies the transient response values for DC bias or applies the transient response you set manually.
|
| DCBiasVoltageRange |
Specifies the DC bias voltage range, in volts, that defines the values to which you can set the DCBiasVoltageLevel for the specified channel(s). For valid ranges, refer to the specifications for your instrument.
|
| SourceApertureTime |
Specifies the LCR source aperture time, in seconds, for a channel in LCR mode.
Use this property to adjust the aperture time for the LCR control loop. In systems that use multiple tones
that are equally spaced, setting this property to 1/(Tone Spacing in Hz) can reduce the impact of external
interference and still maintain an integer number of cycles for all multi-tones. Increasing LCR source aperture
time can increase the required settling time.
|
| VoltageRange |
Specifies the voltage range, in volts RMS, that defines the values to which you can set the VoltageAmplitude for the specified channel(s). For valid ranges, refer to the specifications for your instrument.
|