DCPowerOutputDigitalEdgeStartTrigger.Configure Method
- Updated2024-01-04
- 2 minute(s) read
DCPowerOutputDigitalEdgeStartTriggerConfigure Method
Configures the StartTrigger for digital edge triggering for the specified channel(s).
Namespace: NationalInstruments.ModularInstruments.NIDCPower
Assembly: NationalInstruments.ModularInstruments.NIDCPower.Fx45 (in NationalInstruments.ModularInstruments.NIDCPower.Fx45.dll) Version: 2023
Syntax
public void Configure( DCPowerDigitalEdgeStartTriggerInputTerminal inputTerminal, DCPowerTriggerEdge edge )
Public Sub Configure ( inputTerminal As DCPowerDigitalEdgeStartTriggerInputTerminal, edge As DCPowerTriggerEdge )
Parameters
- inputTerminal
- Type: NationalInstruments.ModularInstruments.NIDCPowerDCPowerDigitalEdgeStartTriggerInputTerminal
Specifies the inputTerminal for the digital edge StartTrigger.
You can specify any valid input terminal. Valid terminals are listed in MAX under the Device Routes tab or in the Signal Routing topic for the instrument.
Specify the input terminal using the form /Dev1/PXI_Trig0, where Dev1 is the instrument and PXI_Trig0 is the terminal. The input terminal can also be a terminal from another instrument or channel. For example, you can set the input terminal on Dev1 to be /Dev2/Engine0/SourceCompleteEvent.
- edge
- Type: NationalInstruments.ModularInstruments.NIDCPowerDCPowerTriggerEdge
Specifies whether to configure the StartTrigger to assert on the rising or falling edge.
Exceptions
| Exception | Condition |
|---|---|
| ObjectDisposedException | The method was called after the associated NIDCPower object was disposed. |
| OperationNotSupportedException | The method was called to unsupported hardware. |
| SelectorNameException | The method was called with an unknown channel name. |
| ArgumentNullException | The method was called with a null input terminal. |
| IviCDriverException | The underlying NI-DCPower driver returned an error. |
Remarks
 Note |
|---|
| This method cannot be called in the Running state. Refer to the Programming States topic in the NI DC Power Supplies and SMUs Help for information about the specific NI-DCPower software states. |
| Note |
|---|
| This method is not supported by all instruments. Refer to the Supported Functions by Device topic in the NI DC Power Supplies and SMUs Help for information about supported instruments. |