DCPowerSource.SequenceLoopCount Property
- Updated2024-01-04
- 1 minute(s) read
DCPowerSourceSequenceLoopCount Property
Gets or sets the number of times a sequence is run after initiation.
Namespace: NationalInstruments.ModularInstruments.NIDCPower
Assembly: NationalInstruments.ModularInstruments.NIDCPower.Fx45 (in NationalInstruments.ModularInstruments.NIDCPower.Fx45.dll) Version: 2023
Syntax
public int SequenceLoopCount { get; set; }
Public Property SequenceLoopCount As Integer Get Set
Property Value
Type: Int32The default value is 1.
Valid values range from 1 to 2147483647.
Remarks
Refer to the Sequence Source Mode topic in the NI DC Power Supplies and SMUs Help for more information about the sequence loop count.
 Note |
|---|
| This property is not supported by all instruments. Refer to the Supported Properties by Device topic in the NI DC Power Supplies and SMUs Help for information about supported instruments. |