SwitchChannel Properties

Specifies whether to enable sharing of an analog bus line so that multiple switch devices can connect to it simultaneously. For each device that will share the analog bus line, set this property to to enable sharing on the channel that connects to the analog bus line. Analog bus sharing is disabled by default.

Indicates in Hertz the maximum frequency of a signal that can pass through the switch without significant deterioration.

Indicates in ohms the switch impedance. This value is important in the RF domain and should match the impedance of the sources and loads.

Indicates in amperes the maximum AC current that the device can carry.

Indicates in watts the maximum AC power that the device can carry.

Indicates in amperes the maximum AC current that the device can switch. This current is always against an RMS voltage level.

Indicates in watts the maximum AC power that the device can switch.

Indicates in volts the maximum AC RMS voltage that the device can switch.

Indicates in amperes the maximum DC current that the device can carry.

Indicates in watts the maximum DC power that the device can carry.

Indicates in amperes the maximum DC current that the device can switch. This current is always against a DC voltage level.

Indicates in watts the maximum DC power that the device can switch.

Indicates in volts the maximum DC voltage that the device can switch.

Specifies how you can use the channel. Using this property acts as a safety mechanism to prevent you from connecting two source channels, for example.

Indicates the number of wires that the channel switches.