Installing the Module

Note For best performance, NI recommends installing temperature modules at the end of the Remote I/O system. Increase typical measuring tolerance up to 0.9 K in temperature modules installed next to a bus coupler.

What to Use

  • REM-11120
  • Mounted bus connector

What to Do

Complete the following steps to install the REM-11120 on the DIN rail.


1378

  1. Align the REM-11120 over the appropriate bus connector.
    Note Verify that the bus connector socket aligns with the socket on the underside of the module.
  2. Press the REM-11120 directly onto the bus connector and DIN rail until it clicks into place.
    Caution Tilting the module when mounting it on the DIN rail will damage the contacts.