Configure Software Edge Start Trigger
- Updated2023-02-17
- 2 minute(s) read
Configure Software Edge Start Trigger
Configures the Start trigger for software triggering.
The digital pattern instrument waits for this trigger after you call niDigital Initiate node or niDigital Burst Pattern node and does not burst a pattern until it receives this trigger. Use the niDigital Send Software Edge Trigger node to send the software trigger to the digital pattern instrument.
Inputs/Outputs
session in
Instrument session obtained from the niDigital Initialize with Optionsnode.
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default value: No error
session out
Handle that identifies the session in all subsequent NI-Digital node calls.
error out
Error information.
The node produces this output according to standard error behavior.