This is an AC (sine) current source.

The Value tab in this component's properties dialog box contains the following:

  Parameter   Description
Current (Pk) The peak current of the source.
Current offset The current offset of the source.
Frequency (F) The frequency of the source.
Time delay The delay from when simulation is started until the source starts producing output.
Damping factor (1/sec) The attentuation of the source's output over time.
Phase The phase of the source. A positive value shifts the sinusoid to the left in accordance with the following equation: A*sin (2πft + Phase) where A is the peak current parameter Current (Pk).
AC analysis magnitude This is initially zero. Set as desired when running an AC Sweep.
AC analysis phase This is initially zero. Set as desired when running an AC Sweep.
Distortion frequency 1 magnitude This is initially zero. Set as desired when running a Distortion.
Distortion frequency 1 phase This is initially zero. Set as desired when running a Distortion.
Distortion frequency 2 magnitude This is initially zero. Set as desired when running a Distortion.
Distortion frequency 2 phase This is initially zero. Set as desired when running a Distortion.
Tolerance The tolerance of the source in %.

  Distortion Analysis parameters are set for each source independently. To perform harmonic distortion analysis use only Distortion frequency 1 magnitude and Distortion frequency 1 phase. If you want to perform an intermodulation distortion analysis you must also use Distortion frequency 2 magnitude and Distortion frequency 2 phase.