Add In Place Pair
- Updated2026-02-04
- 2 minute(s) read
Adds a pair of border nodes at the specified Y Position on an In Place Element Structure.
Parameters
| Name | Data type | Required | Description |
|---|---|---|---|
| Y Position |  |
Yes | Specifies the position relative to the structure border at which to add the border nodes. |
| DPID | |
Yes | Specifies the def proc ID of the border nodes you want to add to the structure. |
Remarks
The following table lists the characteristics of this method.
| Short Name | Add In Place Pair |
| Data type |  |
| Available in Run-Time Engine | No |
| Available in Real-Time Operating System | No |
| Settable when the VI is running | No |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |