The table below shows general values for resistors in either pull-up or pull-down configuration.
Note: Not all devices in a single family will have these values. Please consult your specific device's specifications document for the most accurate information.
Device Family/Name | Pull-up/Pull-down | Resistance |
---|---|---|
NI 63xx (Formerly X Series) |
Pull-down |
50 kΩ |
NI 62xx (Formerly M Series) |
Pull-down |
50 kΩ |
NI 60xxE (Formerly E Series) 1 |
Pull-up |
50 kΩ |
NI 61xx (Formerly S Series) 2 |
Pull-up |
10 kΩ - 100 kΩ |
NI USB-6001/2/3 |
Pull-down |
47.5 kΩ |
NI USB-6008/9 |
Pull-up |
4.7 kΩ |
NI PCIe-6509 |
User-defined 3 |
|
NI 4350/1 |
Pull-up |
10-100 kΩ |
Legacy Devices | ||
Device Name | Pull-up/Pull-down | Resistance |
NI-6533/6534 |
User-defined 3 |
100 kΩ |
PC-DIO-24/96 |
User-defined 3 |
100 kΩ |
PCI-DIO-96 |
Pull-up |
100 kΩ |
AT-DIO-32F |
Pull-Up (IN1, IN2 only) |
4.7kΩ |
AT-MIO-16D/16DE-10 |
Pull-up |
100 kΩ |
PC-LPM-16 |
Pull-up |
10 kΩ |
DAQCard-700 |
Pull-up |
10 kΩ |
1 Some E Series devices have a second chip (the 8255) that provides additional digital lines. On these devices, port 0 uses a 50 kΩ pull-up resistor while ports 2, 3, and 4 use a 100 kΩ pull-up resistor. |
||
3 The DIO-24/96 and the USB-6503/6509 cards allow jumper-selectable pull-up/pull-down configuration. The NI-6533/6534 family of devices similarly allows the user to configure pulled up or pulled down DIO via the DPULL pin. See your user manual for more information. |