Table Of Contents

XNET Write (State » FlexRay Symbol) (G Dataflow)

Last Modified: February 22, 2017

Writes a request for the FlexRay interface to transmit a symbol on the FlexRay bus. You can use this XNET Write node with any input or output session for FlexRay.


session in

The session to use for the symbol write. This session is selected from the LabVIEW project or returned from XNET Create Session. The session must use a FlexRay interface.


error in

Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

Default: No error


session out

An output that is the same as session in, provided for use with subsequent nodes.


error out

Error information. The node produces this output according to standard error behavior.


You can use XNET Write (State FlexRay Symbol) with any XNET session mode, as long as the session interface is FlexRay. Because the symbol write applies to the FlexRay interface, it can apply to multiple sessions.

After calling XNET Write (State FlexRay Symbol), the XNET interface transmits the symbol during the symbol window of the FlexRay cycle following the currently executing cycle. If you call XNET Write (State FlexRay Symbol) multiple times, only the most recent symbol is transmitted.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Supported

Recently Viewed Topics