Configure Arbitrary Waveform (G Dataflow)

Offset value the waveform generator adds to the arbitrary waveform in volts (V).

When you create an arbitrary waveform, you must first normalize the data points to a range of -1.00 to +1.00. You can use this input to shift the range of the arbitrary waveform.

For example, to configure the output signal to range from 0.00 V to 2.00 V, set offset to 1.00.

Factor by which the waveform generator scales the arbitrary waveforms in the sequence.

When you create an arbitrary waveform, you must first normalize the data points to a range of -1.00 to +1.00. You can use this input to scale the waveform to other ranges. The gain is applied before the offset is added.

For example, to configure the output signal to range from -2.00 V to +2.00 V, set gain to 2.00.

Handle that identifies your instrument session previously allocated by Initialize With Channels.

Error conditions that occur before this node runs.

The node responds to this input according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error	error in contains an error
If no error occurred before the node runs, the node begins execution normally. If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.	If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

Default: No error

Name of the waveform generator channel that the node uses.

Arbitrary waveform to produce.

You can create multiple arbitrary waveforms using Create Waveform, which returns a reference that you use to identify each waveform.

Reference to your instrument session to wire to the next node.

Error information.

The node produces this output according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error	error in contains an error
If no error occurred before the node runs, the node begins execution normally. If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.	If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.