Configures the voltage that the output should not exceed when generating the desired current level for the specified channel(s).
The voltage limit setting is applicable only if the output function of the channel is set to DC Current. The channel must be enabled for the specified voltage limit to take effect.
Instrument session obtained from the Initialize With Channels node.
Voltage, in volts, that the output should not exceed when generating the desired current level for the specified channel(s).
The limit is specified as a positive value, but symmetric positive and negative limits are enforced simultaneously.
The valid values for this parameter are defined by the voltage limit range that is configured using the Configure Voltage Limit Range node.
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.
Default: No error
Handle used to identify the session in all subsequent NI-DCPower node calls.
Error information.
The node produces this output according to standard error behavior.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.
Use the Configure Output Function node to set the output function of the channel. The voltage limit configured with the Configure Voltage Limit node is applicable only if the channel is set to the DC Current output function.
Where This Node Can Run:
Desktop OS: Windows
FPGA: Not supported
Web Server: Not supported in VIs that run in a web application