Table Of Contents

DAQmx Create Virtual Channel (Counter Input » Pulse Ticks) (G Dataflow)

Last Modified: July 19, 2019

Creates a channel to measure pulse specifications, returning the measurements as pairs of high ticks and low ticks. With the exception of devices that support multi-counter tasks, you can create only one counter input channel at a time with this node, because a task can contain only one counter input channel. To read from multiple counters simultaneously, use a separate task for each counter. Connect the input signal to the default input terminal of the counter, unless you select a different input terminal.


task in

task in specifies the task to which to add the virtual channels this node creates. If you do not specify a task, NI-DAQmx creates a task for you, and adds the virtual channels this node creates to that task.



counter specifies the name of the counter to use to create the virtual channel. The DAQmx physical channel constant lists all physical channels, including counters, for devices installed in the system.


name to assign

name to assign specifies a name to assign to the virtual channel this node creates. If you do not wire a value to this input, NI-DAQmx uses the physical channel name as the virtual channel name.

If you use this input to provide your own names for the virtual channels, you must use the names when you refer to these channels in other NI-DAQmx nodes, such as the source input of the DAQmx Trigger node.

If you create multiple virtual channels with one DAQmx Create Virtual Channel node, you can specify a comma-separated list of names to assign to the virtual channels. If you provide fewer names than the number of virtual channels you create, NI-DAQmx automatically assigns names to the virtual channels.


source of ticks

source of ticks is the terminal to which you connect a signal to use as the source of ticks. A DAQmx terminal constant lists all terminals available on devices installed in the system. You also can specify a source terminal by wiring a string that contains a terminal name. If you specify OnboardClock, or do not specify any terminal, NI-DAQmx selects the fastest onboard timebase available on the device.


error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.


measurement range

measurement range specifies the minimum and maximum values you expect to measure.


maximum value

maximum value specifies in units the maximum value you expect to measure.


minimum value

minimum value specifies in units the minimum value you expect to measure.


task out

task out is a reference to the task after this node runs. The task contains any newly created virtual channels. If you did not wire a value to task in, NI-DAQmx automatically creates the task this output refers to.


error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices

Web Server: Not supported in VIs that run in a web application

Recently Viewed Topics