Table Of Contents

Discrepancy Warning

Version:
    Last Modified: May 15, 2018

    Discrepancy Warnings are only used in Triple Input (2oo3) configurations. The module FPGA returns a Discrepancy Warning to the User Program when one of the three input channels read a current discrepancy that exceeds the defined parameters.

    spd-note-tip
    Tip  

    To ensure that the module detects and responds to discrepancy warnings, set the discrepancy current parameter as low as the system will allow.

    spd-note-note
    Note  

    You must set the discrepancy current greater than 0 mA.

    You can use AIn.DiscrepancyWarning as a transition condition on the state machine diagram. If a discrepancy warning fault occurs, the User Program will transition to a user-configured state.


    Recently Viewed Topics