Installing the RTI-12308

Figure 1. Installing the RTI-12308 into the SLSC chassis

1378

Caution Do not touch the contacts or remove the I/O boards or cables while the system is energized.

Complete the following steps to install the RTI-12308 in the chassis.

  1. Power off the main DC power source or disconnect it from the chassis before installing any RTIs.
  2. Ensure that the chassis is powered off.
    The POWER LED should be off. If it is not off, do not proceed until it is off.
  3. Loosen the screws of the upper rear panel of the chassis.
  4. Position the RTI-12308 at the desired slot and insert the securing screws, but do not fully tighten them.
  5. Insert an SLSC module into the same slot as its corresponding RTI-12308 while firmly holding the RTI-12308 in place until the RTI-12308 is firmly connected to the module.
  6. Repeat steps 4 and 5 for all required RTIs.
  7. Tighten the screws for all RTI-12308s and the screws of the upper rear panel of the chassis.
    This ensures proper alignment for future connections between modules and RTIs.
  8. Tighten the two module mounting screws on each newly installed module.