C Series Module and CompactDAQ or CompactRIO Hardware Compatibility with LabVIEW

Overview

This page documents the compatibility of C Series modules with CompactDAQ  and CompactRIO Controllers and LabVIEW. It does not include compatibility for CompactRIO Single-Board Controllers.

 

For guidance on selecting cables or accessories for C Series modules, refer to the following documents:

 

 

For a list of what minimum software and driver versions are needed for the modules listed, or what Programming Modes your controller supports, please refer to Software Support for CompactRIO, CompactDAQ, Single-Board RIO, R Series, FlexRIO, and EtherCAT.

CompactDAQ & CompactRIO Controller Compatibility with C Series Modules

Please review the table below for C-Series module compatibility with CompactDAQ and CompactRIO controllers and chassis. If using a Legacy Chassis, for example an NI 9162, please review the section "C Series, Network DAQ, and USB DAQ" under "Device Support in NI-DAQmx" within the relevant NI-DAQmx Driver Readme.

 

ModulesController/Chassis Type
Compact DAQCompactRIOEtherCAT
Programming ModeProgramming Mode
Module NameDescriptionFPGAScanReal-TIme (NI-DAQmx)FPGAScan
AS-i Interface Module
BW 30231-Channel     
CAN Interface Module
NI-98522-Port, Low-Speed/Fault Tolerant C Series      
NI-98532-Port, High-Speed     
NI-98621-Port, High-Speed, Flexible Data Rate, XNET  
CANopen Interface Module
NI-98811-Port  ✔2    
Counter Input Module
NI-936132-Bit, 8-Channel  
Current Input Module
NI-9203200 kS/s, ±20 mA, 8-Channel 
NI-9208500 S/s, ±20 mA, 16-Channel
NI-922750 kS/s/ch, 5 Arms, 24-Bit, 4-Channel 
NI-924650 kS/s/ch, 20 Arms, 30 Apk, 24-Bit, 3-Channel  
NI-924750 kS/s/ch, 50 Arms, 147 Apk, 24-Bit, 3-Channel  
NI-925350 kS/s/ch, ±20 mA, 24-Bit, 8-Channel  
Current Output Module
NI-92654-Channel, 20 mA/16-Bit
NI-92668-Channel, 20mA/16-Bit
DeviceNet Interface Module
NI-98821-Port ✔3    
Digital Module
NI-937530 V, 32-Channel (Sinking Input, Sourcing Output), 7 µs (Input)/500 µs (Output)
NI-94015 V/TTL, 8 Bidirectional Channels, 100 ns
NI-9402LVTTL, 4 Bidirectional Channels, 55 ns
NI-94035 V/TTL, 32 Bidirectional Channels, 7 µs
NI-9411±5 V to 24 V, 6 Differential/Single-Ended Channels, 500 ns
NI-942124 V, 8-Channel (Sinking Input), 100 µs
NI-942224 V to 60 V, 8 Channel (Sinking/Sourcing Input), 250 µs
NI-942324 V, 8 Channel (Sinking Input), 1 µs
NI-942524 V, 32-Channel (Sinking Input), 7 µs
NI-942624 V, 32 Channel (Sourcing Input), 7 µs
NI-9435±5 VDC to ±250 VDC/10 VAC to 250 VAC, 4-Channel (Sinking/Sourcing Input), 3 ms
NI-943620 VDC to 240 VDC/120 VAC to 240 VAC, 8 Channel (Sinking/Sourcing Input), 20 ms
NI-943724 VDC to 250 VDC, 8-Channel (Sinking Input), 1 µs
NI-94705 VDC to 30 VDC, 8-Channel (Sourcing Output), 2 kHz    
NI-947224 V, 8-Channel (Sourcing Output), 100 µs
NI-947430 V, 8-Channel (Sourcing Output), 1 µs
NI-947560 V, 8-Channel (Sourcing Output), 1 µs
NI-947636 V, 32-Channel (Sourcing Output), 500 µs
NI-947760 V, 32-Channel (Sinking Output), 8 µs
NI-947850 V, 16-Channel (Sinking Output), 50 µs
Digitizer Module
NI-9775±10 V, Up to 20 MS/s/ch, 14-Bit, 4-Channel   
EtherCAT Interface Module
cRIO ECAT S2-Port, EtherCAT Slave   
Functional Safety Module
NI-93508-Channel     
NI-93514-Channel      
HART Interface Module
AM-98984-Channel, Master     
LIN Interface Module
NI-98661-Port   
Memory Module
NI-98024 GB, Storage     
Module Development Kit
NI-9951Version 2.0, CompactRIO MDK     
Motor Drive Interface Module
NI-9512Stepper, 1-Axis, Single Encoder   
NI-9514Servo, 1-Axis, Single Encoder     
NI-9516Servo, 1-Axis, Dual Encoder   
Motor Drive Module
NI-9502Brushless Servo    
NI-9503PWM Stepper    
NI-9505Full H-Bridge Brushed    
Multifunction I/O Module
NI-93818 AI, 8 AO, 4 DIO, 0 V to 5 V  
PROFIBUS Interface Module
cRIO-PB-MS1-Port, Master/Slave  ✔5    
cRIO-PB-S1-Port, Slave ✔5    
PROFINET Interface Module
cRIO-PN-S2-Port, Slave ✔5    
Relay Output Module
NI-94814-Channel, SPST Relay, 60 VDC(1 A)/ 250 Vrms (2 A)
NI-94824-Channel, SPST Relay, 60 VDC (1 A)/250 VAC (1.5 A) 
NI-94858-Channel, SSR Relay, 60 VDC/30 Vrms, 750 mA 
RF Receiver Module
NI-977030 kHz to 100 MHz     
Serial Interface Module
NI-98704-Port, RS232   
NI-98714-Port, RS485/RS422    
Sound and Vibration Input Module
NI-92303-Channel, 12.8 kS/s/channel, ±30 V  
NI-92318-Channel, 51.2 kS/s/channel, -5 V to 5 V   
NI-92323-Channel, 102.4 kS/s/channel, ±30 V  
NI-92334-Channel, 24-Bit Accelerometer✔4✔1 
NI-92344-Channel, 51.2 kS/s/channel, ±5 V✔1
NI-92502-Channel, 102.4 kS/s/ch Simultaneous, ±5 V   
NI-98611-Port, Low-Speed/Fault Tolerant  
Strain/Bridge Input Module
NI-923510 kS/s/channel, 120 Ω Quarter-Bridge Strain Gage, 8-Channel 
NI-923610 kS/s/channel, 350 Ω Quarter-Bridge Strain Gage, 8-Channel
NI-923750 kS/s/channel, Bridge Analog Input, 4-Channel
NI-9237 (D-SUB)50 kS/s/channel, Bridge Analog Input, 4-Channel
Synchronization Module
NI-9467GPS Timestamping    
NI-9469Chassis Synchronization  
Temperature Input Module
NI-92104-Channel, 14 S/s Aggregate, ±80 mV
NI-92114-Channel, 14 S/s Aggregate, ±80 mV
NI-92128-Channel, 95 S/s/ch Simultaneous, ±78 mV
NI-921316-Channel, 75 S/s Aggregate, ±78 mV
NI-921416-Channel, 68 S/s Aggregate, ±78 mV, Isothermal 
NI-92168-Channel, 400 S/s Aggregate, 0 Ω to 400 Ω, PT100 RTD
NI-92174-Channel, 400 S/s Aggregate, 0 Ω to 400 Ω, PT100 RTD
NI-92268-Channel, 400 S/s Aggregate, 0 Ω to 4000 Ω, PT1000 RTD
Universal Analog Input Module
NI-921851.2 kS/s/ch, 2-Channel
NI-9219100 S/s/channel, 4-Channel
User Interface Module
NI-93444-Channel
Vehicle Multiprotocol Interface Module
NI-98602-Port, XNET/CAN/LIN  
Voltage and Current Input Module
NI-9207500 S/s, 16-Channel 
Voltage Input Module
NI-9201±10 V, 500 kS/s, 12-Bit, 8-Channel
NI-9202±10 V, 10 kS/s, 24-Bit, 16-Channel  
NI-9205±10 V, 250 kS/s, 16-Bit, 32-Channel
NI-9206±10 V, 250 kS/s, 16-Bit, 32-Channel, 60 VDC Isolation
NI-9209±10 V, 500 S/s, 16-Channel
NI-9215±10 V, 100 kS/s/ch, 16-Bit, Simultaneous Input, 4-Channel
NI-9220±10 V, 100 kS/s/ch, 16-Bit, Simultaneous Input, 16-Channel 
NI-9221±60 V, 800 kS/s, 12-Bit, 8-Channel 
NI-9222±10 V, 500 kS/s/ch, 16-Bit, Simultaneous Input, 4-Channel
NI-9223±10 V, 1 MS/s, 16-Bit, Simultaneous Input, 4-Channel
NI-9224±10 V, 1 kS/s/ch, 24-Bit, Simultaneous Input, 8-Channel
NI-9225300 Vrms, 50 kS/s/ch, 24-Bit, Simultaneous Input, 3-Channel
NI-9228±60 V, 1 kS/s/ch, 24-Bit, Simultaneous Input, 8-Channel
NI-9229±60 V, 50 kS/s/ch, 24-Bit, Simultaneous Input, 4-Channel
NI-9238±500 mV, 50 kS/s/ch, 24-Bit, Simultaneous Input, 4-Channel  
NI-9239±10 V, 50 kS/s/ch, 24-Bit, Simultaneous Input, 4-Channel
NI-9242250 Vrms L-N, 400 Vrms L-L, 50 kS/s/ch, 24-Bit, 3-Channel 
NI-9244400 Vrms L-N, 800 Vrms L-L, 50 kS/s/ch, 24-Bit, 3-Channel
NI-92513 Vrms, 102.4 kS/s/ch Simultaneous, 2-Channel    
NI-9252±10 V, 50 kS/s/ch, 24-Bit, 8-Channel    
Voltage Output Module
NI-926051.2 kS/s/ch Simultaneous, 3 Vrms, 2-Channel   
NI-92621 MS/s/ch Simultaneous, ±10 V, 6-Channel    
NI-9263100 kS/s/ch Simultaneous, ±10 V, 4-Channel 
NI-926425 kS/s/ch Simultaneous, ±10 V, 16-Channel 
NI-9269100 kS/s/ch Simultaneous, ±10 V, Isolated, 4-Channel 
Wireless Gateway Module  
NI-97952.4 GHz Radio      

1 The LabVIEW FPGA Module is recommended for sound and vibration measurement with CompactRIO systems. Modules designed for sound and vibration signals use an onboard, high-speed timing source. Accessing one of these modules using the Scan Mode Interface mode for CompactRIO hardware severely limits the frequency input range and may cause higher frequency signals to alias. 

The NI-9881 C Series CANopen Interface Module requires the LabVIEW FPGA Module to compile for a specific chassis, but the CANopen API is accessed from the real-time program on the host controller, this can be explained further by Software Support for CompactRIO, CompactDAQ, Single-Board RIO, R Series, and EtherCAT. For information about supported hardware and compatibility with NI-RIO, refer to the NI-Industrial Communications for CANopen readme.

3 The NI-9882 C Series DeviceNet Interface Module requires the LabVIEW FPGA Module to compile and does not support all controllers and chassis. For information about supported hardware and compatibility with NI-RIO, refer to the NI-Industrial Communications for DeviceNet readme.

4 This module is no longer supported in LabVIEW FPGA mode as of CompactRIO Device Drivers 17.6 and LabVIEW 2017 SP1. Use a previous version of CompactRIO Device Drivers to continue using these modules in LabVIEW FPGA mode.

5 The PROFIBUS Master/Slave module is only compatible with the Ethernet RIO Expansion Chassis in Slave mode.

Was this information helpful?

Yes

No