The following items are notable issues fixed between the release of ECU Test System Maintenance Software 1.0 and ECU Test System Maintenance Software 21.0, including additional patches and service packs. If you have an issue ID, you can search this list to validate that the issue has been fixed. This is not an exhaustive list of issues fixed in the current version of ECU Test System Maintenance Software.
Bug Number |
Legacy ID |
Description |
Details |
---|---|---|---|
1329655 |
Terminal blocks are incorrectly labeled as cables in failure messagesFailure messages in the report may label terminal block components as cables. Workaround: There is currently no known workaround for this issue. |
Reported Version: ECU Test System Maintenance Software 21.0.0 Resolved Version: ECU Test System Maintenance Software 21.0.1 Added: Mar 9, 2021 |
|
1211012 |
ECUTS-16000/16001 User Manual shows incorrect pins in the J18, J19, J20, and J21 pin map when populated with a PXIe-63784 ground pins are incorrect: B39, A45, B45, and B47. Workaround: The pins should be mapped as follows:
|
Reported Version: ECU Test System Maintenance Software 21.0.0 Resolved Version: ECU Test System Maintenance Software 21.0.1 Added: Mar 9, 2021 |
|
1364766 |
Disconnected load wires are not always detected for RMX-4005 devicesIf an RMX-4005 is just connected to only one set of Load wires, the ECU Test System Maintenance Software's continuity check with a Field Diagnostic Tester (FDT) may incorrectly pass. Workaround: There is currently no known workaround for this issue. |
Reported Version: ECU Test System Maintenance Software 21.0.0 Resolved Version: ECU Test System Maintenance Software 21.0.1 Added: Mar 9, 2021 |
Installing some patches may require certain additional steps or considerations. Please refer to the following table for more information about patches for this release.
These patches currently do not have any special instructions.