NI does not actively maintain this document.
This content provides support for older products and technology, so you may notice outdated links or obsolete information about operating systems or other relevant products.
| ID | Fixed Issue |
|---|---|
| 133351 | Interactive Test Panel and Gain Tuning Panel sometimes show a very small value instead of 0. |
| 156262 | Cannot map SolidWorks sensors to a Home switch. |
| 156263 | Position Compare function block does not work with SolidWorks axes. |
| 165662 | Incorrect error -77044 (bufferUpdateInvalidError) returned when you try to update points during a finite contour move. |
| 166061 | Incorrect fault returned when the SolidWorks simulation reaches the end of its specified duration. |
| 166464 | No error returned when attempting to start a step response in the Gain Tuning Panel dialog box when the axis is not active. |
| 167594 | Position Error Exceeded LED does not work in the Gain Tuning Panel dialog box. |
| 170153 | Switching the NI Scan Engine from Configuration mode to Active mode on an EtherCAT backplane can cause NI 951x modules to fault with a Heartbeat Communication Fault. |
| 170953 | Large SolidWorks assemblies may timeout when starting the simulation the first time. |
| 172448 | Cannot clear faults on NI 951x modules in Active mode if the fault originally occurred in Configuration mode. |
| 173474 | Errors returned when running a VI that uses a SolidWorks axis before deploying the axis. |
| 174572 | Deleting, then re-adding an axis in the Axis Manager dialog box leads to an "Invalid Configuration" error. |
| 175298 | Changes to the digital input mapping using Standard mode do not show up after switching to Graphical mode. |
| 175999 | NI 951x modules cannot be enabled if any module using the NI Scan Engine has a fault. |
| 176269 | You cannot configure Encoder 1 when the Axis Configuration dialog box is set to "Use Graphical Mode." |
| 176793 | Cannot drag NI SoftMotion resources from the LabVIEW Project Explorer window to the block diagram when using NI SoftMotion Module Lite. |
| 178157 | FPGA to RT synchronization VIs are missing from the NI SoftMotion FPGA palette. |
| 178539 | Having two or more simulated axes above any SolidWorks axes in the LabVIEW Project Explorer window causes a NIMC_invalidIndexSpecifiedError (-77075) when switching to Active mode. |
| 178798 | Interactive Test Panel dialog box plots do not work. |
| 178851 | Some SolidWorks error messages are not displayed if the LabVIEW Real-Time module is not installed. |
| 179734 | You cannot run the RT Scan Synchronization VIs faster than 5 ms. |
| 179783 | Position jump when using an NI SoftMotion axis in a coordinate space and then using it outside of the coordinate space as a slave axis. |
| 181155 | Velocity override percentage only applies to current move and is lost when next move starts. |