The following items are notable issues fixed between the release of RFIC Test Software 20.5 and RFIC Test Software 21.5, including additional patches and service packs. If you have an issue ID, you can search this list to validate that the issue has been fixed. This is not an exhaustive list of issues fixed in the current version of RFIC Test Software.
|
Bug Number |
Legacy ID |
Description |
Details |
|---|---|---|---|
| 1777674 |
RFIC Test Software keeps SEM measurement results from previous measurements after disabling SEM measurementAfter performing SEM measurements, RFIC Test Software keeps the SEM measurement results. When you disable SEM measurement and performs a new measurement, the results of previous SEM measurements are displayed in the Summary pane and logged, which is confusing. Workaround: There is currently no known workaround for this issue.
|
Reported Version: RFIC Test Software 19.2 Resolved Version: RFIC Test Software 21.5 Added: Feb 18, 2022 |
|
| 1774050 |
RFIC SFP exchanges TXP.Input PAPR (dB) and TXP.DUT Maximum Input Power (dBm)RFIC Test Soft Front Panel exchanges TXP.Input PAPR (dB) and TXP.DUT Maximum Input Power (dBm) when exporting the test results of power sweeping to a TDMS file, regardless of whether digital predistortion (DPD) is applied.
Workaround: There is currently no known workaround for this issue.
|
Reported Version: RFIC Test Software 19.2 Resolved Version: RFIC Test Software 21.5 Added: Feb 18, 2022 |
|
| 1769487 |
System PAE values in RFIC Results TDMS files do not match test results in the Summary paneIn a hardware setup using multiple DC sources, when you enable system PAE measurement and run power and/or frequency sweep, the system PAE measurement results logged in RFIC Result TDMS files do not match the test results in the Summary pane.
Workaround: Set each sweep point and manually read system PAE measurement results from the Summary pane.
|
Reported Version: RFIC Test Software 19.2 Resolved Version: RFIC Test Software 21.5 Added: Feb 18, 2022 |
|
| 1768541 |
R+jX in RFIC SFP is used as reflection coefficient instead of impedanceRFIC SFP does not support impedance in R+jX when Tuner Mode is R+jX.
Workaround: Enter reflection coefficient instead of impedance in R+jX.
|
Reported Version: RFIC Test Software 21.0 Resolved Version: RFIC Test Software 21.5 Added: Feb 18, 2022 |
|
| 1723873 |
Cannot Compensate Tuner Loss to Power Meter at DUT Output PortRFIC Test Software does not compensate the tuner loss to the power meter at the DUT output port.
Workaround: Read the tuner loss from the Summary pane and manually add to power meter coupling loss at the DUT output port.
|
Reported Version: RFIC Test Software 20.5 Resolved Version: RFIC Test Software 21.5 Added: Feb 18, 2022 |
Installing some patches may require certain additional steps or considerations. Please refer to the following table for more information about patches for this release.
These patches currently do not have any special instructions.