Installing an Interface Adapter Module on the Carrier

Install up to two interface adapter modules on the carrier before installing the carrier in the chassis.

Complete the following steps to install an interface adapter module in Slot 1 on the carrier.
Note When you install both a serial input device and a serial output device, you must install the serial output device in Slot 1. When you install only one interface adapter module, you can use either Slot 1 or Slot 2.
What you need to install the interface adapter module:
  • Four Torx® mounting screws
  • T8 Torx driver
  1. Remove any filler panels from the carrier, if installed. To remove a filler panel, remove the mounting screws that secure the panel to the carrier.
  2. Insert the I/O connectors at an angle through the hole in the front panel.
  3. Align the connector at the rear of the interface adapter module with the interface adapter module board to board connector.
    Figure 11. Aligning the Interface Adapter Module with the Carrier Board to Board Connector

    Aligning the Interface Adapter Module in Slot 1 with the Carrier Board to Board Connector

  4. Push down on the rear of the IVN device until it fully mates with the board to board connector.
  5. Secure the interface adapter module to the carrier using the four Torx mounting screws. Use a T8 Torx driver and tighten to 0.31 N·m (2.7 in-lb).
    Figure 12. Securing the Interface Adapter Module on the Carrier

    Screw locations on the Interface Adapter Module

  6. To install a second interface adapter module in Slot 2, repeat these steps.
(Optional) Install the auxiliary power connector if needed by the application. For instructions, refer to the Installing the Auxiliary Power Connector on the Carrier in the user manual for your carrier.