NationalInstruments.RFmx.InstrMX

Represents errors that occur during RFmx application execution.

Defines a root class which is used to identify and control Instr signal configuration.

Specifies constants for I/O terminals.

Represents a list. Implement this interface to expose measurement functionality.

Represents a signal configuration. Implement this interface to expose measurement functionality.

Specifies whether the advance trigger is a digital edge or a software trigger.

Specifies whether the RF IN connector is AC- or DC-coupled on the downconverter.

Specifies how to obtain the lowest noise floor or faster measurement speed.

Specifies whether dithering is enabled on the digitizer.

Specifies whether the tunable preselector is enabled on the downconverter.

Routes signals (triggers, clocks, and events) to the specified output terminal.

Specifies the delay duration units and interpretation for LO settling.

Specifies whether input isolation is enabled.

Specifies whether to enable the LO2 OUT terminals in the installed devices.

Enables in-band retuning and specifies the current frequency of the RF downconverter. This value is expressed in Hz.

Specifies whether to reduce the effects of the instrument leakage by placing the LO outside the band of acquisition.

Specifies whether to use fractional mode for the LO phase-locked loop (PLL).

Specifies the RFmx session with the respective LO sharing mode.

Specifies the format of parameters to interpolate.

Specifies the configurations to skip while loading from a file using the LoadConfigurations(string) method

Specifies whether RFmx chooses an attenuation setting based on the hardware settings.

Optimizes RF path for the signal bandwidth that is centered on the IQ carrier frequency.

Specifies whether to enable the digitizer OSP block to delay Reference Triggers, along with the data samples, moving through the OSP block.

Configures error reporting for ADC and overflows occurred during onboard signal processing. Overflows lead to clipping of the waveform.

Specifies the personality of the signal if the signal exists.

Specifies whether the RF preamplifier is enabled in the system.

Specifies all the attribute identifiers.

Specifies whether RFmx computes the RF attenuation.

Returns the recommended acquisition type for the last committed measurement configuration. This method is supported when
1. RFmxInstrMX(string, string) is called with option string "AnalysisOnly=1".
2. RFmxInstrMX(string[], string) is called with option string 'AnalysisOnly=1;MaxNumWfms:n'. Use 'instr(n)' as the selector string to read this method.

Returns the recommended FFT window type for spectral acquisition. This method is supported when
1. RFmxInstrMX(string, string) is called with option string "AnalysisOnly=1".
2. RFmxInstrMX(string[], string) is called with option string 'AnalysisOnly=1;MaxNumWfms:n'. Use 'instr(n)' as the selector string to read this method.

Specifies the orientation of the data in the S2P file relative to the port you specify. The default value is Port2TowardsDut.

Returns the type of S-parameter to apply to measurements on the specified port for a Calplane. You can use the selectorString input to specify the name of the Calplane and port to configure for s-parameter.

Specifies the self-calibration step.

Specifies whether RFmx validates the self-calibration data.

Specifies the active edge for the start trigger. This method is used only when you set the SetStartTriggerType(string, RFmxInstrMXStartTriggerType) method to DigitalEdge.

Specifies whether the start trigger is a digital edge or a software trigger.

Makes tradeoffs between tuning speed and phase noise.