Manual Mode
- Updated2023-12-28
- 1 minute(s) read
Manual Mode
Manual mode allows you to select the control mode, the setpoint settings, and the gradients individually. The gradients adjust the current setpoint values to the new setpoint settings by a ramp function.
There are two different ways to update the setpoint settings:
- Sequential update—Each setpoint and gradient is updated in the test immediately when you change the value.
- Synchronized setting—Change all setpoints and gradients one after the other without updating them immediately in the test. After you change all the values, you can update them all at the same time. This method allows you to define a time instead of a gradient for adapting the current setpoint to the new setpoint setting.
Note The inclination of this ramp is limited by the hardware that you use. If the selected
settings cannot be realized, the inclination of the ramp is reduced.
Related Information
- Using Manual Mode
- Configuration of the Application Library
The Application Library contains different application configurations for each application object.
- Configuration of the Test Library for Powertrain Component Test
The test library contains one group folder T0?_* for each category of parameters that can be linked to the test. The first group folder T00_Customer is always reserved for customer-specific adaptions.
- Configuration of the Test
There are two methods that you can use to change an existing test.