Generation Configuration

Configures the specified trigger.

Configures the voltage levels for the data, trigger, and event channels. You can use either predefined logic families or custom voltage levels.

Sets the Initial state for a dynamic generation operation.

Specifies how many times to generate a waveform or whether it should be continuously generated.

Sets the state of the channels when the dynamic generation operation is idle. The operation may be idle when the generation operation completes normally, when the generation operation pauses from an active Pause trigger, or when the generation operation terminates because of an underflow error. You can specify idle state in either a binary or a string format.

Configures the data position delay with respect to the Sample clock.

Configures the various ways the data is clocked relative to the Sample clock.

Use this VI to route signals (clocks, triggers, and events) to the output terminal you specify. Refer to your device documentation for valid signal destinations.

Forces a channel into a high-impedance state. The effect is immediate; it does not require the session be committed. The channel remains tristated regardless of what other software commands are called. Call this VI again and wire FALSE to the tristate terminal to allow other software commands to control the channel normally.

Use the Adv Timing VIs to configure advanced timing features.

Use the Scripting VIs to create and configure scripts for your generation operation.

Use the Waveform Control VIs to configure the waveforms in your generation operation.