Use these VIs to interact with or create pin maps. Refer to the Pin and Channel Map Editor topic for more information about configuring pin and channel maps.

niDigital Load Pin Map VI
Loads a pin map file.
niDigital Enable Sites VI
Enables the sites you specify. All sites are enabled by default. NI TestStand Semiconductor Module requires all sites to always be enabled, and manages the set of active sites without disabling the sites in the digital pattern instrument session. Do not use this VI with the Semiconductor Module.
niDigital Disable Sites VI
Disables the sites you specify. Disabled sites are not included in pattern bursts initiated by niDigital Initiate VI or niDigital Burst Pattern VI, even if the site is specified in the list of pattern burst sites in niDigital Configure Pattern Burst Sites VI or in the site list parameter of the niDigital Burst Pattern VI. Additionally, if you specify a list of pin or pin group names in a channel list parameter in any NI-Digital VI, digital pattern instrument channels mapped to disabled sites are not affected by the VI. VIs that return per-pin data, such as niDigital PPMU Measure VI, do not return data for channels mapped to disabled sites.
niDigital Is Site Enabled VI
Checks if a site you specify is enabled.
Low Level
Use these VIs to configure low-level settings of pin maps and pin groups. Use these VIs if you are not loading a pin map file using the niDigital Load Pin Map VI.

Parent topic: Configuration

NI-Digital Pattern Driver LabVIEW VI Reference