Action

Use the NI-Digital Pattern Driver nodes to run test programs on a digital pattern instrument.

Uses the start label you specify to burst the pattern on the sites you specify. Digital pins retain their state at the end of a pattern burst until the first vector of the pattern burst, a call to Write Static, or a call to Apply Levels and Timing.

Use the Source and Capture nodes to create, configure, write, and fetch source and capture waveforms with the NI-Digital Pattern Driver.

Use the Sequencer Flags and Registers nodes to create and configure sequencer flags and registers.

Use the Static nodes to program read and write static states for the pin driver.

Use the PPMU nodes to source voltage or current from the PPMU and measure voltage or current from the DUT.

Use the Frequency Count nodes to measure frequency.

Use the Clock Generator nodes to drive a free-running clock at a specified frequency from a digital pin.

Use the History RAM nodes to fetch History RAM cycle information.

Use the Low Level nodes to perform low-level tasks with a digital pattern instrument.