Representation
- Updated2025-07-30
- 1 minute(s) read
Gets or sets the data type on the numeric control.
Remarks
The following table lists the characteristics of this property.
| Short Name | Rep |
| Data type |  |
| Permissions | Read/Write |
| Available in Run-Time Engine | Yes (Read Only) |
| Available in Real-Time Operating System | Yes |
| Settable when the VI is running | No |
| Loads the front panel into memory | Yes |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |
| Extended Precision | 0 | |
| Double Precision | 1 | |
| Single Precision | 2 | |
| Long | 3 | |
| Word | 4 | |
| Byte | 5 | |
| Unsigned Long | 6 | |
| Unsigned Word | 7 | |
| Unsigned Byte | 8 | |
| Complex Extended | 9 | |
| Complex Double | 10 | |
| Complex Single | 11 | |
| Quad | 12 | |
| Unsigned Quad | 13 | |
| Fixed-Point | 14 |