To reset your FieldDAQ device to factory-default settings, complete the following steps.

  1. Verify the power source is turned off.

  2. Connect Ethernet port 0 and port 1 with an Ethernet cable.

    Figure 31. Connecting Port 0 and Port 1


  3. Turn on the power source to the device. After about 15 seconds, the STATUS LED blinks red indicating that the device has been restored to factory-default settings.
  4. Reconnect the Ethernet port 0 to the host.
  5. Turn off and then turn on the power source to the device.

The FieldDAQ device factory-set defaults are listed in the following table.

Table 11. Device Default Settings
Attribute Value
Hostname FD11614-<serial number>
IP DHCP or Link Local
Comment Empty
Default login User name = admin

Password = no password required