Receiving the ECUTS

When the ECUTS shipping crate arrives at the facility, store the crate indoors in an area that meets the following conditions.

ECUTS Storage Conditions
Ambient Temperature 0 °C to 60 °C (32 °F to 140 °F)
Relative Humidity 10% to 80%, non-condensing
Pollution Degree 2

Ensure the facility can accommodate the ECUTS shipping crate, which has the following dimensions and maximum weight.

Table 5. ECUTS Shipping Crate Dimensions and Weight
Specification ECUTS-16001 Shipping Crate
Width 1,390 mm (54.7 in.)
Depth 1,259 mm (49.6 in.)
Height 2,475 mm (97.4 in.)
Maximum Weight, Including ECUTS[1]1 Maximum weight of an ECUTS as configured by NI. 600 kg (1,323 lb)
Weight of Crate Without ECUTS 150 kg (331 lb)

NI recommends a suitable lifting apparatus, such as a pallet jack, for transporting the ECUTS shipping crate around the facility.

If the facility cannot accommodate the ECUTS shipping crate, unpack the shipping crate and move the ECUTS using its mounted casters.

Inspecting the Shipment

Notice Do not discard any parts or packaging until you complete the ECUTS bring-up and setup process. Do not reject the ECUTS shipment.
  1. Before you open the crate, inspect the tilt sensors on the sides of the crate.
Note A red sensor indicates that the sensor was activated during delivery.
Figure 23. ECUTS Shipping Crate Sensors

1378

  1. Tilt Sensor Sticker
  2. Tilt Sensor
  1. Inspect the crate for any damage.
  2. Review the packing list attached to the crate.
  3. Accept the shipment.
Contact NI if the tilt sensor on the crate is activated or the crate is damaged.

Unpacking the ECUTS

Caution To avoid injury, do not stand directly in front of the ECUTS when loading or unloading the ECUTS from the shipping crate.
Attention Ne pas se tenir directement devant le ECUTS lors de son chargement ou déchargement dans/depuis sa caisse d'expédition.
Note The ECUTS-16001 shipping crate requires a clearance of at least 4 meters (13 ft) in front of the crate to lay out the crate ramp and roll the ECUTS-16001 out of the crate.

Equipment

  • Scissors, knife, or box cutter
  1. Release the six latches securing the front panel to the crate.
  2. Lower the top end of the front panel onto the base of the shipping crate.
  3. Insert the notched top of the front panel into the groove on the bottom of the crate opening to use the front panel as a ramp.
  4. Verify the crate ramp is secure.
  5. Inspect the accessories for any physical damage.
  6. Unlatch and remove the upper and lower battens holding the ECUTS-16001 in place.
  7. Unlock the brakes on the two visible caster wheels.
  8. With two people, slowly roll the ECUTS-16001 out of the crate and down the ramp.
  9. Open and remove the poly antistatic bag from the ECUTS-16001.
  10. Inspect the ECUTS-16001 for any physical damage.
Contact NI Support if:
  • The ECUTS-16001 is physically damaged.
  • Any additional materials or boxes are physically damaged.
  • The contents of the ECUTS-16001 crate do not match the sales agreement or packing list.

1 Maximum weight of an ECUTS as configured by NI.