Configures the Source Mode property. Specifies whether to run a single output point or a sequence.

Note NI-DCPower uses the terms "source" and "output". However, while sinking with electronic loads and SMUs these correspond to "sinking" and "input", respectively.

Related topics:

Single Point Source Mode

Sequence Source Mode


icon

Inputs/Outputs

  • civrn.png instrument handle —

    instrument handle identifies a particular instrument session.

  • cstr.png channel name —

    channel name specifies the channel(s) to use. Specify the channel(s) using the form PXI1Slot3/0,PXI1Slot3/2-3,PXI1Slot4/2-3 or PXI1Slot3/0,PXI1Slot3/2:3,PXI1Slot4/2:3, where PXI1Slot3 and PXI1Slot4 are instrument resource names and 0, 2, and 3 are channels.

    If you do not wire this parameter, all channels in the session are used.

  • ci32.png source mode —

    source mode specifies the source mode for the specified channel(s).

    Single Point (1020)

    Applies a single source configuration.
    Sequence (1021)

    Applies a list of voltage or current configurations sequentially.
  • cerrcodeclst.png error in (no error) —

    error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

  • iivrn.png instrument handle out —

    instrument handle out passes the handle used to identify the session in all subsequent NI-DCPower VI calls.

  • ierrcodeclst.png error out —

    error out contains error information. This output provides standard error out functionality.