Mounting the USB-6509 to a Board or Panel

To mount the USB-6509 to a board or panel, complete the following steps while referring to the following figure.
Figure 19. Mounting the USB-6509 to a Panel

1378

Note Do not apply the rubber feet to the USB-6509 when panel mounting the device.
  1. Go to ni.com/r/rd3233 to download and print the panel mounting template PDF.
  2. Using the template, mark the bottom point and the top point on the panel. The points will be 162 mm (6.375 in.) from each other.
  3. Remove the USB cable from the connector on the USB-6509.
  4. Screw a #8 or M4 screw into the bottom point on the panel.
  5. Set the USB-6509 on the screw by fitting it into the bottom screw notch on the underside of the USB-6509.
  6. Screw a #8 or M4 screw through the USB-6509 top screw hole into the panel.