SET-2210 Specifications

Definitions

Warranted Specifications describe the performance of a model under stated operating conditions and are covered by the model warranty.

Characteristics describe values that are relevant to the use of the model under stated operating conditions but are not covered by the model warranty.

  • Typical—describes the performance met by a majority of models.
  • Nominal—describes an attribute that is based on design, conformance testing, or supplemental testing.
  • Measured—describes the measured performance of a representative model.

    • Values are Typical unless otherwise noted.

    Conditions

    Specifications are valid under the following conditions unless otherwise noted.

    • All voltages are relative to GND unless otherwise noted.

    Physical Characteristics

    Table 1. Physical Characteristics
    Dimensions (HxWxD) 10 mm x 52 mm x 235 mm (0.39 in x 2.04 in x 9.25 in)

    For more information, visit ni.com/dimensions and search by module number.
    Weight 382 g (13.47 oz)
    Front board-to-board connector (X1) 2x20 pin female socket terminal strip
    Back board-to-board connector (X2) 2x20 pin terminal strip

    Electrical Characteristics

    Table 2. Maximum Initial Contact Resistance
    Channel signal to fault bus 500 mΩ
    Table 3. Relay Expected Electrical Lifetime
    1 A, +30 VDC resistive 105 operations
    1.5 A, +30 VDC resistive 104 operations
    Table 4. Update Time
    Update Time 10 ms

    Power Specifications

    Caution The values in these tables are the maximum rated values for the SET-2210, however when plugged into an SLSC module, the rated value may be lower. Check the documentation of the SLSC module and use the lower of the rated values.
    Table 5. Channel Signals, Fault Bus
    Maximum input voltage, any pin (channel-to-channel, channel-to-ground) +/-60 VDC
    Maximum switching power (DC resistive load) 60 W
    Caution Do not supply hazardous voltages (>30 V RMS/42 Vpk/60 V DC) to the SET-2210.
    Table 6. SLSC Bus
    Maximum current rating 1.5 A
    Current sum of all channels 3 A

    Environmental Guidelines

    Notice Failure to follow the mounting instructions in the product documentation can cause temperature derating.
    Notice This product is intended for use in indoor applications only.

    Environmental Characteristics

    Table 7. Temperature
    Characteristic Specification
    Operating 0 °C to 40 °C chassis intake
    Storage -40 °C to 85 °C
    Table 8. Humidity
    Characteristic Specification
    Operating 10% to 90% relative, non condensing
    Storage 5% to 95% relative, non condensing
    Table 9. Pollution Degree
    Characteristic Specification
    Pollution degree 2
    Table 10. Maximum Altitude
    Characteristic Specification
    Maximum altitude 2000 m
    Table 11. Shock and Vibration
    Characteristic Specification
    Operating vibration 5 Hz to 500 Hz, 0.3 g RMS
    Non-operating vibration 5 Hz to 500 Hz, 2.4 g RMS
    Operating shock 30 g, half-sine, 11 ms pulse
    Non-operating shock 50 g, half-sine, 11 ms pulse