Specifies the array of ohmic losses between the noise source and input port of the analyzer during calibration, as a function of frequency. This value is expressed in dB. This loss is accounted for by the noise figure (NF) measurement when you set the NF Cal Loss Comp Enabled property to True. You must exclude any loss specified by the NF Y-Factor NS Loss property.

This property specifies the frequencies at which the NF Cal Loss Freq property measures the losses.

You do not need to use a selector string to configure or read this property for the default signal instance. Refer to the Selector Strings topic for information about the string syntax for named signals.

The default value is an empty array.

Remarks

The following table lists the characteristics of this property.

Short Name NF Cal Loss (dB)
Data type c1ddbl.png
Permissions Read/Write
High-level VIs N/A
Resettable Yes