Specifies the power level of the signal at the LO OUT terminal when the RFMXINSTR_ATTR_LO_EXPORT_ENABLED attribute is set to TRUE. This value is expressed in dBm.

Syntax

RFMXINSTR_ATTR_LO_OUT_POWER

Numeric Value

Data Type

Access

Applies To

79

float64

Read/Write

Lo

Remarks


For PXIe-5830/5831/5832, if you want to configure or read on LO1 or LO2 channel, use "lo1" or "lo2" as part of the selector string. You do not need to use a selector string or use "lo1, lo2" as part of the selector string if you want to configure this attribute for both channels. You can also use RFmxInstr_BuildLOString utility function to create the LO String. For all other devices, lo channel string is not allowed.
Note

This attribute is not supported on a MIMO session.

You do not need to use a selector string if you want to configure this attribute for all signal instances. Specify the signal name in the selector string if you want to configure or read on that signal instance. Refer to the Selector String topic for information about the string syntax.

The default value is 0.

Supported devices: PXIe-5830/5831/5832/5840/5841/5842