This section describes how to install the PXIe-6672 hardware and software and how to configure the device.

Installing the Software

Refer to the readme.htm file that accompanies the NI-Sync software for software installation directions.

Note Be sure to install the driver software before installing the PXIe-6672 hardware.

Installing the Hardware

The following are general installation instructions. Consult the chassis user manual or technical reference manual for specific instructions and warnings about installing new modules.

  1. Power off and unplug the chassis.
  2. Choose an available slot in the chassis. The PXIe-6672 can be installed in a System Timing Slot (marked by either a square glyph or a square glyph with a circle inside of it), or in a non-timing PXI Express (PXIe) slot.
    Note Star trigger functionality and the ability to replace PXI_CLK10 are not available when the PXIe-6672 is installed in a non-timing PXIe slot.
    Figure 1. System Timing Device Slot Indicator Glyph without Circle


    Figure 1. System Timing Device Slot Indicator Glyph on the PXIe-1062Q Chassis


    Note The slot number printed on the glyph may vary from chassis to chassis.
  3. Remove the filler panel for the PXI slot you located in step 2, if applicable.
  4. Ground yourself using a grounding strap or by holding a grounded object. Follow the ESD protection precautions described in the Unpacking section of the Introduction.
  5. Remove any packing material from the front panel screws and backplane connectors.
  6. Insert the PXIe-6672 into the PXI Express slot. Use the injector/ejector handle to fully insert the module into the chassis.
  7. Screw the front panel of the device to the front panel mounting rail of the chassis.
  8. If adjacent slots are not populated, use EMC filler panels to cover the opening.
    Caution
    • To ensure the specified EMC performance, you must install PXI EMC filler panels, National Instruments part number 778700-01, in all open chassis slots.
    • To ensure the specified EMC performance, operate this product only with double-shielded cables and accessories (for example, RG-223 cables).
  9. Visually verify the installation. Make sure the module is not touching other modules or components and is fully inserted into the slot.
  10. Plug in and power on the chassis.

The PXIe-6672 is now installed.

Configuring the Module

The PXIe-6672 is completely software configurable. The system software automatically allocates all module resources.

The two LEDs on the front panel provide information about module status. The PXIe-6672 Front Panel section describes the LEDs in greater detail.