Use the NI-SWITCH scan VIs to configure a scan of an NI switch.

niSwitch Initiate Scan VI
Commits the configured scan list and trigger settings to hardware and initiates the scan. If the niSwitch Commit VI was called earlier, niSwitch Initiate Scan only initiates the scan and returns immediately.
niSwitch Abort Scan VI
Aborts the scan in progress. The switch module returns to the state it was in before the scan was initiated. Use the niSwitch Initiate Scan VI to initiate an aborted scan.
niSwitch Send Software Trigger VI
Sends a software trigger to the switch module specified in the NI-SWITCH session.
niSwitch Wait For Scan To Complete VI
Pauses until the switch module stops scanning or the maximum time has elapsed and returns a timeout error.
niSwitch Switch Is Scanning VI
Indicates the status of the scan.
niSwitch Configure Scan List VI
Configures the scan list and scan mode used for scanning.
niSwitch Configure Scan Trigger VI
Configures the scan triggers for the scan list established with the niSwitch Configure Scan List VI.
niSwitch Set Continuous Scan VI
Sets the switch to loop continuously through the scan list or to stop scanning after one pass through the scan list.
niSwitch Commit VI
Downloads the configured scan list and trigger settings to hardware.
niSwitch Route Trigger Input VI
Routes the input trigger from the front or rear connector to a trigger bus line (TTLx). To disconnect the route, call this VI again and select None for the trigger input bus line parameter.
niSwitch Route Scan Advanced Output VI
Routes the scan advanced output trigger from a trigger bus line (TTLx) to the front or rear connector.

Parent topic: NI-SWITCH

NI-SWITCH LabVIEW VI Reference

Log in to get a better experience