NI-SCOPE Properties

Table of Contents

Triggering:Onboard Signal Processing:Ref Trigger Min Quiet Time Property

  • Updated2023-02-21
  • 1 minute(s) read

Short Name: Ref Trigger Min Quiet Time

Property of niScope

Specifies the amount of time (in seconds) the trigger circuit must not detect a signal above the trigger level (or below the trigger level if the trigger slope is negative) before the trigger is armed. This property is useful for triggering at the beginning of signal bursts instead of in the middle of signal bursts. The default value is 0.

Note  This property can be used only with high-speed digitizers that support onboard signal processing (OSP). NI-SCOPE returns an error if you use this property with a device that does not support OSP.

Valid Values

Any value greater than or equal to 0.

Remarks

The following table lists the characteristics of this property.

Datatype fD
PermissionsRead/Write
High-level VIs N/A
Channel-based No
ResettableNo

Log in to get a better experience