Configure Software Reference Trigger
- Updated2023-02-17
- 2 minute(s) read
Configure Software Reference Trigger
Configures the Reference trigger for software triggering.
If the Reference trigger asserts before the required number of pretrigger samples are acquired, it is ignored. Use the Send Software Edge Triggernode to assert the trigger condition. This node is valid only for acquisition sessions.
Inputs/Outputs
session in
Instrument session obtained from the Initialize Acquisition Sessionnode, the Initialize Generation Sessionnode, or the Initialize External Calibrationnode.
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default value: No error
pretrigger samples
The number of pretrigger samples the device must receive before the Reference trigger is acknowledged.
Default value: 500
session out
Handle that identifies the session in all subsequent node calls.
The session out parameter is obtained from the Initialize Acquisition Sessionnode or the Initialize Generation Sessionnode.
error out
Error information.
The node produces this output according to standard error behavior.