Configuration

Use these nodes to configure a digital pattern instrument.

NI-Digital Pattern Driver Nodes
Use the NI-Digital Pattern Driver nodes to run test programs on a digital pattern instrument.
Pin Map
Use the Pin Map nodes to interact with or create pin maps.
Low Level
Use these nodes to configure low-level settings of pin maps and pin groups if you are not loading a pin map file using the niDigital Load Pin Mapnode.
Select Function
Specifies whether digital pattern instrument channels are controlled by the PPMU, Digital, disconnected, or off. Changes take effect immediately.
Levels and Timing
Use the Levels and Timing nodes to configure levels and timing. Levels and timing can be configured through levels and timing sheets or directly through configure node parameters.
Levels
Use the Levels nodes to program the voltage levels, termination mode, and active load levels on each channel or pin of a digital pattern instrument when not using levels sheets.
Time Set
Use the Time Set nodes to program time sets for a digital pattern instrument when not using timing sheets.
TDR
Use these nodes to measure pin propagation delay using Time-Domain Reflectometry (TDR) and to apply delay values to the pins of a digital pattern instrument.
Pattern
Use these nodes to load and unload digital patterns and to specify patterns to burst.
Trigger
Use these nodes to configure triggers.
PPMU
Use the PPMU nodes to configure the current and voltage levels that the PPMU outputs or measures to the DUT.
DC Voltage
Use the DC Voltage nodes to change channel settings when the channel is configured for DC voltage.
DC Current
Use the DC Current nodes to change channel settings when the channel is configured for DC current.
Frequency Count
Use the Frequency Count node to configure measurement time for frequency counters.
History RAM
Use the History RAM nodes to configure History RAM cycle information.