Specifies a limit for positive voltage slew rate, in volts per microsecond, for output cutoff. If the voltage increases at a rate that exceeds this limit, the output is disconnected.

Syntax

Namespace: NationalInstruments.ModularInstruments.NIDCPower

public double VoltageChangeLimitHigh { get; set; }

Remarks

To find out whether an output has exceeded this limit, call the QueryLatchedOutputCutoffState method with OutputCutoffReasonVoltageChangeHigh as the outputCutoffReason.

Note

NI-DCPower uses the terms "source" and "output". However, while sinking with electronic loads and SMUs these correspond to "sinking" and "input", respectively.

Note

This property is not supported by all instruments. Refer to the Supported Properties by Device topic in the NI DC Power Supplies and SMUs Help for information about supported instruments.

Represents a threshold on positive voltage slew rate for output cutoff.