The Carrying Handle for CompactRIO & CompactDAQ kit (part number 786744-01) includes one handle that you can attach to most multi-slot NI CompactDAQ, CompactRIO, and EtherCAT chassis and controllers. This article documents which chassis and controllers are compatible with the Carrying Handle.
This page is part of the CompactDAQ System Accessory Compatibility Guide.
The following chassis and controllers are fully compatible with the Carrying Handle. The chassis ground screw can remain installed with the Carrying Handle equipped.
Note: A Carrying Handle can be installed on the left and/or right sides of cRIO-903x, cRIO-904x, and cDAQ-913x (excluding cDAQ-9138 and cDAQ-9139). A Carrying Handle can only be installed on the right side of all other models.
Correct installation of the Carrying Handle requires removing and losing access to the chassis ground screw on the following chassis and controllers.
The following chassis and controllers are not compatible with the Carrying Handle.