This Automotive Ethernet sample project shows the configuration of an automotive network restbus simulation.

To deploy this example, you must connect Automotive Ethernet hardware to your system and enable both the transmitter and receiver.

You must use two interconnected Ethernet ports. Configure their names in NI-MAX as ENET1 and ENET2.

In VeriStand

After you install the toolkit, you can find an example folder through the following path: %Public%\Documents\National Instruments\NI VeriStand\Examples.
Note The directory depends on the VeriStand version already installed. If you have more than one version of VeriStand installed on your computer and you installed the toolkit for all VeriStand versions, the example is available for each version.
As soon as the example loads, you can deploy your project and start working with your Automotive Ethernet hardware and the example.

In LabVIEW

After you install the toolkit, navigate to the following path to locate the example: %Program Files%\National Instruments\LabVIEW\examples\Vehicle Communication Toolkit\VCOM Full Examples\VCOM Full - Signals Single Point Ethernet.vi.

This example demonstrates how to use the API for Automotive Ethernet signals in single-point mode.