Specifies the amount of time in seconds the DMM waits between measurement cycles. This property only applies when the Sample Trigger property is set to INTERVAL. The default value (-1) ensures that the DMM settles for a recommended time, which is the same as using an immediate trigger.

The NI 4065 and NI 4070/4071/4072 use the value specified in this property as additional delay. On these devices, the onboard timing resolution is 34.72 ns and the valid range is 0-149 s.

Only positive values are valid when setting the sample interval.

Note The NI 4080/4081/4082 are not supported.

Remarks

The following table lists the characteristics of this property.

Short Name Sample Interval
Data type cdbl.png
Permissions Read/Write
High-level VIs niDMM Configure Multi Point
Resettable No