Specifies the behavior of the Source trigger.

Note NI-DCPower uses the terms "source" and "output". However, while sinking with electronic loads and SMUs these correspond to "sinking" and "input", respectively.
Note This property is not supported by all devices. Refer to Supported Properties by Device for information about supported devices.

Default Value :Refer to Supported Properties by Device for the default value by device.

Note To specify a channel name when accessing this property, you must first initialize the session using the Initialize With Independent Channels VI.

Remarks

The following table lists the characteristics of this property.

Short Name Source Trigger Type
Data type ci32.png
Permissions Read/Write
High-level VIs niDCPower Configure Digital Edge Source Trigger, niDCPower Configure Software Edge Source Trigger, niDCPower Disable Source Trigger
Channel-based Yes
Instrument-based No
Resettable No
Digital Edge 1014

The data operation starts when a digital edge is detected.
Software Edge 1015

The data operation starts when a software trigger occurs.
None 1012

No trigger is configured.