Connecting Signals to Analog Output
- Updated2023-02-17
- 1 minute(s) read
Connecting Signals to Analog Output
There are no configuration settings for the analog output channels. All of the analog output channels are single-ended. Each analog output is always referenced to the analog ground (AGND). The following table shows the channel mapping.
| Application Board Terminals | Signal | |
|---|---|---|
| Bank A | A/AO0 | AO 0 |
| A/AO1 | AO 1 | |
| Bank B | B/AO0 | AO 0 |
| B/AO1 | AO 1 | |
| AGND | Analog Ground | |
Notice Use AGND for analog signals
only.
You can use the NI ELVIS III Prototyping Board to access these signals. The following diagram shows the NI ELVIS III with the analog output terminals highlighted.
