Execution:Close After Call
- Updated2025-07-30
- 1 minute(s) read
Indicates whether to close the front panel after the VI runs.
Note Use this property in conjunction with the Show Front Panel On Call property.
Remarks
The following table lists the characteristics of this property.
| Short Name | Exec.CloseFPAfterCall |
| Data type |  |
| Permissions | Read/Write |
| Available in Run-Time Engine | Yes |
| Available in Real-Time Operating System | Yes |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |