If TRUE, enables automatic error handling for a VI.

By default, LabVIEW automatically handles any error that occurs when a VI runs by suspending execution, highlighting the subVI or function where the error occurred, and displaying an error dialog box.

This property is similar to the Enable automatic error handling in new VIs option on the Block Diagram page of the Options dialog box and the Enable automatic error handling option on the Execution page of the VI Properties dialog box.

Note The LabVIEW Run-Time Engine does not support automatic error handling.

Remarks

The following table lists the characteristics of this property.

Short Name Auto Err Handling
Data type cbool.png
Permissions Read/Write
Available in Run-Time Engine No
Available in Real-Time Operating System No
Settable when the VI is running No
Loads the front panel into memory No
Need to authenticate before use No
Loads the block diagram into memory No
Remote access allowed Yes
Must wait until user interface is idle No
Available with control VIs No
Available with global VIs No
Available with strict type definitions No
Available with polymorphic VIs No