niVMS Locations Editor VI

niVMS Locations Editor VI

Displays the Measurement Locations Editor window, but only if there is a video signal already stored in the video buffer. If the signal is composite, you can specify the CVBS Channel. If a measurement locations file has not already been loaded (using the niVMS Configure VI), a prompt is displayed to open a new file. When saved, the edited file is used as the new set of measurement locations.

Note:  NI recommends that you configure measurement locations using either the niVMS Measurement Locations VI or the NI VMS user interface. Use of this VI is no longer recommended, as typically VIs should not launch user interfaces.

	Amplitude Units for NTSC specifies whether to use IRE or mV units for NTSC/525-line signals. The default value is mV.
	Error In describes error conditions that occur before this node runs. This input provides standard error in functionality.
	Locations File contains information about the current locations file. description returns the description of the measurement locations file. file path returns the path of the measurement locations file.
	Error Out contains error information. This output provides standard error out functionality.