How Do I Change My IP Address Using My Computer?

  1. Open or create a project including the USRP-2974 as described in Adding Your Device to a Project.
    Note If the device cannot be connected in SystemDesigner due to an incorrect or unknown IP address, set up a temporary IP address for the device as described in How Do I Change My IP Address without Using My Computer?.
  2. Select Network Adapters on the target in SystemDesigner.
  3. Select Configure Network Settings on the Configuration pane.
  4. Select the network adapter that you want to change the settings for using the addresses defined in the following table.
    Table 2. Ethernet Port Addressing
    Ethernet Port Addressing Port Description
    eth0 1G ETH RJ45
    eth1 Internal 10G ETH
    eth2 External SFP+ 1G/10G ETH 0
    Note The external SFP+ 1G/10G ETH 1 port does not have access to the system on module (SoM).
  5. Set the mode.
  6. Set the address if the mode is static.
  7. Click Apply.